Information
MMCX RF Connectors
MMCX connector is one series of RF connectors. This MMCX connector is jack/ female, and straight bulkhead type. Its design is to be terminated with RF Coaxial Cable by crimping to be MMCX adaptor RF cable. The applicable RF coax cable is RG178/ 1.48mm/ RG196 RF coaxial cables. Its plating is Gold over brass and the impedance is 50 ohm.
MMCX connector is kind of small in RF connector. MMCX Connectors has snap-on coupling design. Besides, MMCX jack crimp series still have Right angle jack , straight crimp jack, PCB mount jack, edge mount jack and SMT jack. MMCX Connector commonly is used for 0~3GHz. If you need higher working frequency, special mechanical design requests, or need to custom RF connector and RF connector cables, please contact us.
MMCX connector jack straight bulkhead crimp type can be terminated with RG178/ 1.48mm/ RG196 RF coaxial Cable to be RF Cable assembly. It can transmit RF Signal well in telecommunications. MMCX RF connector is most commonly used in GPS internal Antenna, GSM external Antenna or GPS/GSM application these kinds of RF industry.
Part Numbers
| P/N | RF connector description | Cable Group | Ohm |
| C06AB30178007 | MMCX RF connector straight bh. crimp jack | RG178, RG196, 1.48mm | 50 |
Cable Assembly
Cable assembly Instructions Crimp type
Step1. All parts of MMCX connector are shown as the top line
Step2. Strip the cable into center conductor, insulator, shielding three parts per recommended stripping dimension shown in connector spec.
Step3. Slide the ferrule onto the cable jacket.
Step4. Put the cable inner conductor into the main body to touch contact pin and then solder it, and then spread out the shielding onto the knurled part.
Step5. Proceed the first open-short test to make sure signal transmit well.
Step6. Slide the ferrule over the main body and crimp it to let it become tighter.
Step7. Wear the heat shrink onto the ferrule and then shrink it.
Step8. Do the open-short test of every cable assembly before QC examination.
Specification
MMCX Connector Specification
| Electrical | |
| Impedance | 50 ohm |
| Frequency range | 0 ~ 6 GHz |
| VSWR | Straight type ≦ 1.3 max. |
| R/A type ≦ 1.5 max. | |
| Dielectric withstanding voltage | 500 V rms |
| Working voltage | 170 V rms |
| Center contact resistance | ≦ 5.0 mΩ (Milliohms max.) |
| Outer contact resistance | ≦ 2.5 mΩ (Milliohms max.) |
| Insulation resistance | ≧ 103 MΩ (Megohms min.) |
| Mechanical | |
| Coupling | Lock-snap |
| Contact Retention | 2.3 lbs min. |
| Mating Durability | 500 cycles min. (For Beryllium copper contact only) |
| Environmental | |
| Temperature Range | Teflon -65°C ~ +155°C |
| Vibration | MIL-STD-202 Meth. 204 |
| Corrosion resistance | MIL-STD-202 Meth. 101 |
| Materials | |
| Body, coupling nut | Brass |
| Insulator | Teflon |
| Center contact | Brass for male, |
| Beryllium copper for female | |
| Crimping sleeve | Annealed Brass |
| Body plating | Gold (Ag) |
| Center contact plating | Gold (Ag) |
Note: These characteristics are typical and may not apply to all connectors.
