MMCX Straight Crimp Plug for RG178,RG196

MMCX Straight Crimp Plug for RG178,RG196

Information


This MMCX Straight plug connector has snap-on coupling mating and is designed to be crimped with coaxial cable like RG178 and RG196.

The biggest characteristic of MMCX plug is its “C-clip”

This MMCX Straight Crimp plug is machined of RoHS compliant copper, and has gold plating.

Part Numbers

P/N Cable Group Ohm
C05AA3F178003C RG178, RG196 50

Cable Assembly

Cable Assembly Instructions Crimp type

Assembly Instructions: Step1 Step1. All parts of MMCX connector are shown as the top line.

Assembly Instructions: Step2 Step2. Strip the RG174 into center conductor, insulator, shielding three parts per recommended stripping dimension shown in connector spec.

Step3. Slide the ferrule onto the cable jacket.

Assembly Instructions: Step3 Step4. Put the center conductor into the contact pin of MMCX plug and then solder through the hole.

Assembly Instructions: Step4 Step5. Put the contact pin into main body until it stops and then spread out the shielding onto the knurled part and then

Assembly Instructions: Step5 Step6. Slide the ferrule over the shielding, and proceed the first open-short test to make sure signal can transmit well.

Assembly Instructions: Step6 Step7. Crimp the ferrule to let it become tighter.

Assembly Instructions: Step7 Step8. Wear the heat shrink onto the ferrule and then shrink it.

Step9. Do the open-short test of every cable assembly before QC examination.

TOP

Specification

MMCX Connector Specification

Electrical
Impedance 50 ohm
Frequency range 0 ~ 6 GHz
VSWR Straight type ≦ 1.3 max.
R/A type ≦ 1.5 max.
Dielectric withstanding voltage 500 V rms
Working voltage 170 V rms
Center contact resistance ≦ 5.0 mΩ (Milliohms max.)
Outer contact resistance ≦ 2.5 mΩ (Milliohms max.)
Insulation resistance ≧ 103 MΩ (Megohms min.)
Mechanical
Coupling Lock-snap
Contact Retention 2.3 lbs min.
Mating Durability 500 cycles min. (For Beryllium copper contact only)
Environmental
Temperature Range Teflon -65°C ~ +155°C
Vibration MIL-STD-202 Meth. 204
Corrosion resistance MIL-STD-202 Meth. 101
Materials
Body, coupling nut Brass
Insulator Teflon
Center contact Brass for male,
Beryllium copper for female
Crimping sleeve Annealed Brass
Body plating Gold (Ag)
Center contact plating Gold (Ag)

Note: These characteristics are typical and may not apply to all connectors.

TOP