MMCX connector jack straight for edge mount

MMCX connector jack straight for edge mount


MMCX RF Connectors

MMCX connector is one kind of RF connectors. This MMCX connector is jack/ female and straight type with edge mount outlook (only 2 legs). It’s designed to terminate with PCB from side. Its plating is Gold over brass and the impedance is 50 ohm.

MMCX connector is small size compared with MCX RF connectors. MMCX Connector is designed to be snap-on coupling. Besides, MMCX jack crimp series still have Right angle jack, straight bulkhead crimp jack, straight jack, SMT jack and PCB jack. MMCX Connector commonly is used for 0~3GHz. If you need higher working frequency, special mechanical design, customized RF connectors, or RF cables, please contact us.

MMCX connector jack straight edge mount type can be soldered on PCB from edges and transmit RF Signal. MMCX RF connector is most commonly used in GPS Antenna, GSM Antenna or W-LAN application these kinds of RF connectors or RF antenna industry.

Part Numbers

P/NRF connector descriptionOhm
C06AN30P00409MMCX RF connector straight edge mount jack50



Impedance50 ohm
Frequency range0 ~ 6 GHz
VSWRStraight type ≤ 1.3 max.
R/A type ≤ 1.5 max.
Dielectric withstanding voltage500 V rms
Working voltage0170 V rms
Center contact resistance≤ 5.0 mΩ (Milliohms max.)
Outer contact resistance≤ 2.5 mΩ (Milliohms max.)
Insulation resistance≥ 103 MΩ (Megohms min.)
Contact Retention2.3 lbs min.
Mating Durability500 cycles min. (For Beryllium copper contact only)
Temperature RangeTeflon −65ºC ~ +155 ºC
VibrationMIL-STD-202 Meth. 204
Corrosion resistanceMIL-STD-202 Meth. 101
Body, coupling nutBrass
Center contactBrass for male,
Beryllium copper for female
Crimping sleeveAnnealed Brass
Body platingGold (Ag)
Center contact platingGold (Ag)

Note: These characteristics are typical and may not apply to all connectors.